h6. [[Programmer's Reference Manuals]] h6(. » [[*Commands]] h6((. » *Configure Ignore h2. *Configure Ignore h4. Use This *Command sets the configured printer ignore character. h4. Syntax *Configure Ignore [_ASCII_code_] h4. Parameters |<^{width:8em}. _ASCII_code_|<^. ASCII code (0 – 255)| h4. Notes The default value is 10 (ASCII linefeed). A value of 0, sets the ignore character to ASCII code 0. Any change made, will only take effect on the next hard reset. h4. See also * [[OS_Byte 5]] * [[OS_Byte 6]] * [[OS_Byte 182]] * [[OS_Byte 246]] * [[*Configure|*Configure]] * [[*Ignore|*Ignore]]