h6. [[SDIODriver]] h6(. » [[SDIODriver *Commands|*Commands]] h6((. » *SDIOSlots h2. *SDIOSlots h4. Use This *Command prints out a table of information about the current configuration of each SDIO slot. h4. Syntax *SDIODevices h4. Parameters None. h4. Notes Typical output might look like the following: <pre> Bus Slt Voltage Width Frequency 0 0 1.8 V 8-bit 52 MHz DDR 1 0 1.8 V 4-bit 208 MHz SDR 2 0 3.0 V 4-bit 50 MHZ SDR 3 0 1.8 V 1-bit 25 MHz SDR 3 1 1.8 V 1-bit 25 MHz SDR 3 2 3.3 V 1-bit 25 MHz SDR </pre> h4. See also * [[*SDIODevices]]