Missing toolbox modules?

I have been trying to use RO5 on RPCEmu. Just to make sure , this is for a copy running in Linux.

I have used stable rom and discimage , but complains about the toolbox modules not being found.

Same for latest rom and image. What am I doing wrong?!

That is strange, because most Toolbox modules are in the ROM!
*Rommodules should show then (if you can run it!)

Yes they are in ROM. Unplugged.

It sounds like you need to do the RPCEmu equivalent of clearing CMOS. I remember having ‘fun’ with it when switching ROMs in the past!

Something to reset the status of all modules is probably the answer.
I can’t recall the magic key combination for power on.
Having something that only rest the module status would be handy though.

Manually (or small utility) listing all unplugged modules and "Insert"ing them would do.
Output of ROMmodules filtered for status of Unplugged, pick up the Name of each match and RMInsert it.

Or there’s OS_Byte 161 and 162

Yes they are in ROM. Unplugged.

You don’t have UnplugTBox running somewhere in the boot sequence, by any chance?

You don’t have UnplugTBox running somewhere in the boot sequence, by any chance?

Oooh, I think that’s a good call as Michael has been working with RO4.02 as the ROM in the early stages. 4.02 needs to do that to bring in the disk based updates.
How quickly we forget that replacing the whole “ROM” is just a few mouse clicks but it was not always so.

I wonder if that UnplugTBox could be modified to only run when the OS is 4.x?

I think the standard advice, which he will remember anyway, is to rename the old !Boot and install the one from the HardDisc4 zip file on the ROOL downloads and then pull in specific items from the old, renamed, !Boot as needed.
That also avoids bringing in a bucket load of 26 bit items that ages to find.

Cmos was the trick, i reverted to cmos.ram from the rpcemu distribution.. configured it in linux , problem solved!
Thanks!