RiscCAD on Titanium

I have been trying to install RiscCad on the Titanium (RISC OS 5.29 06/01/22) from the original CD (V9). It seems to install OK but when I run it it gives the error message: No such mnemonic 3006.
It runs fine on the RISC PC (RISC OS 6)

I am told that the version on !store does work but since I bought the discs from David at a show the ugrade button is unsurprisingly greyed out.

One thing that strikes me as odd is it doesn’t ask for the serial number when I install it.

Any ideas?

Geoff.

Hi Geoff, I’ve had a look and my copy does the same on RPCEmu, looks like the compactor I use doesn’t get on with some of the assembler. It’s odd because other versions seem to work OK.

You are missing out on a lot of new features by sticking with Rev 9.

With regards the serial number, it was pre-programmed by me when the copy was sold, it will not ask you for it.

If you wish to message me your email, I can send an old uncompressed !RunImage which will work, albeit a little slower than the compressed version.

Hi David, thank you for your reply. You can email me at: thebears at onetel dot com and I will give it a whirl.