Which port to use to update an OpenPandora to version 5.22

Dear all

I own an openpandora running RiscOS 5.20.
I want to upgrade to version 5.22. I naively thought I could use the riscos rom from the BeagleBoard port. So, I rename the current riscos to riscos520 and copy the riscos 5.22 rom to the Loader folder… But it does not work. An error occured during startup.
Hopefully, I have been able to go back to riscos 5.20 simply by renaming the riscos file.

So, I am wondering how I can update to version 5.22.

Thank you for your help.

François

I mean my last Image is 5.22 based. Is a 4GB Image. Works without changes on the Pandora and the Beagleboard (not xM!).

You can do it by yourself. Copy the ROM and dont’t forget to “merge in” the 5.22 HDImage!!!

Hello Raik

Thank you for you reply.
But how can I extract the riscos file? I am unable to open the img file and navigate into it.
WinRAR complains it is corrupted :(

Thank you for your help

François

I use 7zip with WIN but only for the FAT partition and USBit to write the unextract image to the card. The FileCore partition is not readable in WIN.
If you have a working card, you need the ROM for the Loader folder (you do so) and the HDImage. Set the type of the Image to utility and extract. “Merge in” !Boot via Configure (doubleclick to !Boot… Boot… Install ), you should change the other content of the Image. You can do this later.

Hello Raik

Thank you very much. Thanks to your image, I could copy/paste the right version of riscos image.
But my question remains: where did you get this image? WHich port did you use?

Thank you again

François

The Beaglboard ROM is working with the Pandora (Both OMAP3). And HardDisc4 is the normally from ROOL…
The Image is a “stolen” RPi RC14 one. I have change the bootfiles in !Boot.Loader and any other configure settings.

Hi Raik, your last image works fine with my Pandora. Good work! Still trying to come to grips with the low resolution of this handheld…