Delete me: Raspberry Pi 4 port status (Rev #41, changes)
Showing changes from revision #40 to #41:
Added | Removed | Changed
Overview
Work on porting RISC OS to the Raspberry Pi 4 is still ongoing. Some components are not available, so this build is not yet suitable for new users.
For users that wish to assist in the testing, a development ROM image is available from the Downloads page – be sure to choose the one marked “Beta RPi ROM”.
Current status
Components that work
| Date | Details |
|---|---|
| 03 Sep 2019 | UART0 fixed: access to the command line via the serial port now works. |
| 13 Sep 2019 | Add GICv2 interrupt controller support. |
| 16 Feb 2020 | Audio output now works. |
| 18 Feb 2020 | USB devices now visible via USB-C (power input) port. |
| 03 May 2020 | Ethernet port now works. |
Major components needing attention
| Item | Comments |
|---|---|
| USB ports | The Pi 4 has a USB3 controller, which RISC OS does not yet support. |
Other restrictions
- The second HDMI port cannot be used at present.
- For the model fitted with 8GB RAM, only 4GB is available to RISC OS.
How to get RISC OS running on the Pi 4
See Software information: Raspberry Pi: Firmware for has details of the firmware required for the Raspberry Pi 4, along with details of the changes needed to config.txt.
The non-availability of the USB ports is a limiting factor. To use RISC OS on the Raspberry Pi 4, you have three options:
- Option 1: Back-power the Pi 4 with a hub connected to the USB-C port.
- If you have board revision
1.21.4 of the Pi4,4 (e.g. if it is the 8GB model) aUSB hub with Power Deliverymaywill work. - If you have board revision
1.1,1.1 or 1.2, Power Deliverywillmay not work.Notethatrelativelyfewhubswillback-powerintheabsenceofPowerDelivery–checkthe
Note that relatively few hubs will back-power in the absence of Power Delivery – check the forum for suggestions.
- If you have board revision
- Option 2: Supply power to the GPIO pins, e.g. by means of a “power input” HAT. This allows an “ordinary” USB hub to be connected to the USB-C port.
- Option 3: Connect using VNC (either via the Ethernet port or by means of the WiFi HAT for the Raspberry Pi) – as no USB devices are needed, a standard power supply can be connected to the USB-C port. You will have to set up the VNC software on another Raspberry Pi before transferring the SD card to the Pi 4.
Further information
- ROOL announcement (02 July 2019)
- Discussion thread in the General forum
- Discussion thread in the Porting RISC OS forum
For more general information, see Using RISC OS on the Raspberry Pi.
Social
and
ROOL Store
Buy RISC OS Open merchandise here, including SD cards for Raspberry Pi and more.