Showing changes from revision #5 to #6:
Added | Removed | Changed
The SD card images linked to here can be written using one of the utilities linked to on the ROOLGeneric OMAP port setup information thanks community members trying to make it easier for the community to get going with page. If you encounter a problem in using these images, please raise it in the forum.RISC OS on particular hardware platforms, however unfortunately we’ve had to remove this page.
Pre-built SD card images include GPL licence binaries which cannot be released without accompanying source code, but ROOL don’t supply source to some of the components that were included. Things like the low level U-Boot and X-Loader bootloaders were of unknown vintage in the images that this page pointed to. The SD card images here were also getting a bit out of date.
System | File |
---|---|
BeagleBoard | SDImageBB.zip? |
BeagleBoard-xM3 | SDImageBBxM.zip? |
DevKit8000 | SDImageDevKit8000.zip? |
IGEPv2 | SDImageIGEPv2.zip? |
Touch Book | SDImageTB.zip? |
Pandora | SDImagePandora.zip? |
The historical revisions of this page are still in the Wiki but the attached files have been removed to make sure we’re GPL-compliant.
1Please see the The above are basic images built using the software pagesROM for up to date download information. If you think we can do more to make it easier to get released by RISCROOL OS running, please make suggestions in the dated 01-Aug-2011. Blank forumCMOS. Thanks! settings are included.
2 Note that an additional separate procedure must be followed in order to use the full boot sequence.
3 Note the loader in the BeagleBoard-xM image supports the rev A board. The MLO and u-boot.bin should be updated if a later rev is used.