*SDIOSlots (changes)

Showing changes from revision #0 to #1: Added | Removed | Changed

SDIODriver

» *Commands

» *SDIOSlots

*SDIOSlots

Use

This *Command prints out a table of information about the current configuration of each SDIO slot.

Syntax

*SDIODevices

Parameters

None.

Notes

Typical output might look like the following:

Bus Slt  Voltage  Width  Frequency
  0   0   1.8 V   8-bit   52 MHz DDR
  1   0   1.8 V   4-bit  208 MHz SDR
  2   0   3.0 V   4-bit   50 MHZ SDR
  3   0   1.8 V   1-bit   25 MHz SDR
  3   1   1.8 V   1-bit   25 MHz SDR
  3   2   3.3 V   1-bit   25 MHz SDR

See also

• *SDIODevices